Shear Stresses in a Brass and Steel Shaft Subjected to Torque

Related BrainMass Solutions

• Stress Conditions, Etc.

  The shaft is subjected to a torque of 7 kN.m and a vertical cantilever load of 10 kN at the end of the shaft. (i) Show, by means of a sketch, the critical positions on the surface of the shaft, where the maximum stresses occur.

• Principle Stresses for Elements

  304817 Principle Stresses for Elements The figure shows a schematic of typical steel (E=200GPa, v=0.3) kneed support. The shaft has a diameter of 16mm. The dimensions are a=150mm and b=300mm and the forces are F=100N, P=75N and P2=50N.

• Working Speed in RPM

  In the above drawing, one can see that each bolt is submitted to shear stresses because of tangential loads which all together determine the torque.

• Largest Allowable Square Cross Section

  Word doc attached gives calculations to find the largest allowable cross section of a described steel shaft in revolution.

• Ideal solutions concerning rotating solid and hollow shafts

  Find the diameter of a solid shaft resulting in a transmission Torque of 50 kNm for a maximum allowable Shear Stress in the shaft of 100 MPa The important parameters to note here are Transmission Torque, T=50kNm=50,000 Nm Maximum allowable Shear stress

• Exam sample question in Applied Mechanics

  31551 Applied Mechanics A solid shaft 125mm did transmits 600kW at 300 revolutions/minute. It is also subjected to a bending moment of 9kN-m and to an end thrust.

• Steel Shaft Design

  370281 Torsional shear stress, shear strain in steel Materials Science Problem (check ) : A hollow steel shaft has an external diameter of 500 mm and an internal diameter of 250 mm- The shft transmits 25 x 10^3 kW a t 160 rpm .

• Determine Maximum Shearing Stress

  160673 Determine Maximum Shearing Stress The torques shown are exerted on pulleys A, B, and C. Knowing that both shafts are solid, determine the maximum shearing stress in (a) shaft AB, (b) shaft BC.

• Calculating shear stress and angle of twist

  If the material modulus is 80GN/m^2 and a torque of 38 Nm is applied at the smaller, what is the maximum shear stress in each part of the shaft and the angle of twist? Explain and show calculations.