Angle at which Compressive Force Becomes Zero

Related BrainMass Solutions

• Compressive force on a rod

  ., determine the angle theta at which the compressive force in the rod becomes zero (see attachment for an illustration) answer should be 48.2 deg. Not sure how to get there though. Hello and thank you for posting your question to Brainmass!

• Pin-Joint Analysis : Direction and Magnitudes of Support Reactions; Load and Nature of Load of Canopy

  final vertical check on the sum of forces at pin D should yield a net of zero: R2 sin(beta) = 3.642815243 kN compressive force of R2 and member 7 is 3.642895243 +3.642925098 = 7.285820341 The vertical compression of member 3 is 6.9282 kN so I

• modelling projectile motion problem

  (see attached figure) Hence, initial speed, u = sqrt(u_h^2 + u_v^2) = sqrt((u*cos(theta))^2 + (u*sin(theta)^2) = sqrt ( 20^2 + 14.7^2) = 24.82 m/s e) Angle at which the football hits the ground = theta == angle at which the football was kicked

• Energy conservation, centripetal acceleration and force, and projectile.

  When the mass reaches the point where force N becomes zero, contact is lost. The angle is then angle b and the speed is V.

• A Vertical Column and Compressive Strength

  75895 Vertical Columb & Compressive Strength A vertical column has the cross-sectional area shown in Fig1. (dimensions mm). The column carries a vertical compressive point-load of 300kN at C. Calculate the following: 1.

• Which material would have the strongest compressive strength?

  172103 Which material would have the strongest compressive strength? 1) Which material would have the strongest compressive strength?

• Determine Maximum Allowable Load

  Here, strain = 0.001/2 = 0.0005 Stress = E*strain = 30*103*0.0005 = 15 MPa, which is created by a force of P = Stress*Area = 15MPa*80,000*10-6 = 1.2 MN We want to find out how much additional force would bring the compressive stress up from 15MPa to

• Developing total energy, amplitude and maximum speed

  Thus the equation becomes: (11) x = (.10 m) cos (12 t + Qo) in which Qo could be a positive or a negative angle. Step 12.

• Compressive stress analysis

  A compression force is a squashing force pushing at both ends of a component or structure along its length.