Determine the maximum allowable stress

Related BrainMass Solutions

• Determine Maximum Allowable Load

  Before the load P is applied, the middle post is shorter than the others by an amount s=1.0 mm. Determine the maximum allowable load Pallow if the allowable compressive stress in the concrete is equal to 20 MPa.

• maximum allowable stress

  : The maximum allowable stress is clarified.

• Ideal solutions concerning rotating solid and hollow shafts

  Find the diameter of a solid shaft resulting in a transmission Torque of 50 kNm for a maximum allowable Shear Stress in the shaft of 100 MPa The important parameters to note here are Transmission Torque, T=50kNm=50,000 Nm Maximum allowable Shear stress

• Mechanics: Bending Moment

  Using an allowable stress of 100 MPa, how do I determine the largest bending moment which may be applied to the bar shown when the radius of the semicircular grooves is 20 mm?

• Max load calculation for a steel pipe

  The maximum load and allowable compressive stress points are determined.

• Maximum load P

  Determine the maximum load P that can be transmitted by the joint if: a) The maximum normal stress on a cross-section of the plates at the pin must not exceed 400 MPa.

• Largest Allowable Square Cross Section

  160671 Largest Allowable Square Cross Section Determine the largest allowable square cross section of a steel shaft of length 6 m if the maximum shearing stress is not to exceed 135 MPa when the shaft is twisted through one complete revolution.

• Endurance limit

  According to the Marin method, in which the laboratory test-determined Se of the particular material (tested on optimized samples) is adjusted to estimate the maximum cyclic stress a particular part can survive, the adjustment of Se is the result of six

• Mechanics of Materials

  Knowing that the allowable shearing force is 360 lb in each lag screw, how would I determine the largest permissible longitudinal spacing (s) of the lag screws, and the maximum shearing stress on the beam?