Purchase Solution

Transients in R-L-C circuits

Not what you're looking for?

Ask Custom Question

Please see attached file on Transients in RLC circuits and Laplace transform.

Please complete the following examples and show detailed workings and narratives including transposition of formula and graphical display where required.

Attachments
Purchase this Solution
Purchase this Solution
Free BrainMass Quizzes
Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

Air Pollution Control - Environmental Science

Working principle of ESP

View More Free Quizzes
Related BrainMass Solutions

  • RL/RC Circuits

    17113 RL/RC Circuits A series RL circuit with L = 3.00 H and a series RC circuit with C = 3.00 have equal time constants. If the two circuits contain the same resistance R, (a) What is the value of R and (b) What is the time constant?

  • Circuits: AC/DC

    What is the ideal total current into the L and C branches of a parallel circuit at resonance?

  • Word problem dealing with current and circuits

    When the switch is closed in the circuit below, the current begins to build up according to the equation: I=E/R[1-e^-(R/L)t] where I is current in amps, t is Time in seconds E is voltage R is resistance in ohms and L is inductance in henrys V=

  • Solving for Alternating Currents

    Problem 70 for reference: A series of RLC circuits with L=10 mH, C=2uF, and R= 5 omega are driven by a generator with a maximum emf of 100V and a variable angular frequency w.

  • Circuit analysis - Differential Equation

    Electric Circuits. Figure 8.2(a), page 318, shows an electric circuit which has an electromotive force, a resistor, and an inductor connected in series.

  • Series tuned resonant circuit

    1) Quality factor of a resonant LRC circuit is given by : Q = 1/R x sq.root(L/C) = (1/20) sq.root(300x10^-6/0.1x10^-6) = 2.74 Band width = R/(2 x pi x L) = 10610 Hz 2) Resonant frequency = 1/[2 x pi x sq.root(LC)] As Resonant frequency = 2000

  • LCR Circuits: Phase difference between voltage and current.

    138743 LCR Circuits: Phase difference between voltage and current. Given that R=1 kilo ohm, C= 1micro farad and L= 100 milli Henry's calculate the frequency at which the current in an LCR series circuit lags the supply voltage by 45 degrees.

  • Electrical Circuits with Bulbs

    Since the current supplied by the battery in the two circuit is same, LR = 40R or L = 40 cm. This solution determines the current through bulbs and also length of wires using equivalent circuits and application of Kirchoff's Laws.

  • Length of a Wire Required for a Circuit

    To have the same current, the total resistance R should be the same in both circuits. Now, R is proportional to l, length and in ckt. A, we have 20 cm and 20 cm in parallel, then series with 30 cm.

View More Related Solutions