Purchase Solution

Design with Multiplexer

Not what you're looking for?

Ask Custom Question

I need some help answering this question: (I am not sure what C is, but it might mean complement)
Design a circuit using one 16 TO 1 multiplexer with W, X,Y,Z on the control inputs. Let w be the most significant bit and Z the least significant bit on the control inputs:

The equation of the circuit is:
F= (Y+Z)(CW+CX+WX)+YZ

Purchase this Solution
Solution Summary

This in-depth solution shows step-by-step calculations of how to design a circuit with multiplexer, with n inputs and k control inputs. All workings and formulas used are shown for better understanding.

Solution Preview

Hello and thank you for posting your question to Brainmass!

The solution is attached below in two files. the files are ...

Purchase this Solution
Free BrainMass Quizzes
Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

Air Pollution Control - Environmental Science

Working principle of ESP

View More Free Quizzes
Related BrainMass Solutions

  • Encoder

    330398 Multisim, Mod-100 BCD counter, Octal-to-binary switch encoder, 16-channel 1-bit multiplexer, AHDL, Comparator 1. Using Multisim, design a mod-100 BCD counter that drives a 2-digit, 7-segment display. The count sequence will be 0 through 99.

  • Truth Table, Logic Diagram, and Logic Symbol for Multiplexer

    542054 The solution gives detailed steps on making truth table, drawing logic table for the multiplexer. An example of 3-input and 5 bit multiplexer is explained in details. Prepare a 3-input, 5 bit multiplexer that fits in a 24-pin IC package.

  • Multiplexer, Stuff Bits

    [ An analogous situation would be that you are pouring water in a drum (considering steady state condition, that is, it is already filled with water to start with) at a rate of 2 Litre/sec.

  • QPSK / Multiplexer

    236998 QPSK / Multiplexer Need help with a QPSK / Multiplexer question. please see attached. thank you. Additional information has been provided for this question: There are 20 sources. Each source transmits at 32kbps.

  • Multiplexer and Synchronization Questions

    Determine the bandwidth required to support the multiplexer output for 10 analog voice signals digitized using standard PCM and a TDM multiplexer with an overhead of 10%. Assume a bandwidth efficiency of 2-bps/Hz. 3.

  • Sampling frequency and bit rate of transmission

    Assuming that the Time Division Multiplexer reads data from each video camera at same rate as the sampling frequency i.e. 3.6 M times per second, each time slot for the multiplexer is (1/3.6M)th of a second.

  • Boolean Function

    278676 Boolean Function Multiplexer and External Gates. Implement the following boolean function with a 4x1 multiplexer and external gates. Connect inputs A and B to the selection lines.

  • Nyquist Bandwidth

    Determine the bandwidth required of the media (at Point D) given the following: a. 20-analog voice signals digitized using standard G.711 PCM; a TDM multiplexer with an added output overhead of 15%; and a modem that employs QPSK modulation.

  • Multiplexer Conversion

    23757 Multiplexer Conversion 2. Given a 16-to-1 Multiplexer, how many of the following are required: a) Inputs _______ b) Outputs _____ c) Control signals ______ 3.

View More Related Solutions