Purchase Solution

Electrical Circuits

Not what you're looking for?

Ask Custom Question

Please see the attached file.

Attachments
Purchase this Solution
Solution Summary

Step-by-step solution provided that discusses electrical circuits.

Solution Preview

Please refer to the attachment.

Problem 17
25 kohm

Neon lamp 4 μF 110V

a) Voltage across the capacitor at any instant t after it starts charging up is given by :

V = Vm(1 - e-t/RC) where Vm = Max voltage = 110 V, R = 25 kohm, C = 4 μF

RC = 25x103x4x10-6 = 0.1

Or V = 110 (1 - e-t/0.1)

To determine the time taken for the capacitor to charge up to a voltage of 75 V, we substitute V = 75 V in the above equation and solve for t.

75 = 110 (1 - e-t/0.1) or e-t/0.1 = 0.318

Taking loge of both the ...

Purchase this Solution
Free BrainMass Quizzes
Introduction to Nanotechnology/Nanomaterials

This quiz is for any area of science. Test yourself to see what knowledge of nanotechnology you have. This content will also make you familiar with basic concepts of nanotechnology.

Intro to the Physics Waves

Some short-answer questions involving the basic vocabulary of string, sound, and water waves.

The Moon

Test your knowledge of moon phases and movement.

Variables in Science Experiments

How well do you understand variables? Test your knowledge of independent (manipulated), dependent (responding), and controlled variables with this 10 question quiz.

Basic Physics

This quiz will test your knowledge about basic Physics.

View More Free Quizzes
Related BrainMass Solutions

  • Occupational Health and Safety- Emergency Procedures

    Fire due to electrical fault can occur due to following reasons: • Routine maintenance of electrical circuits • Lack of complete knowledge of concerned personnel • Poor electrical installation • Faulty electrical equipment • Wet weather conditions

  • Finding appropriate source for the electrical load

    15003 Finding appropriate source for the electrical load Have four circuits. One takes 9Vdc, two 5Vdc, and last one takes 12Vdc. Have variable transformer for source.

  • Circuits: AC/DC

    (Please see the attachment) This solution provides an explanation of the given electrical circuits problem and includes illustrations of the circuits for the students visual understanding.

  • Different Logic family Gates

    Although they are not designed for linear operation, RTL integrated circuits are sometimes used as inexpensive small-signal amplifiers, or as interface devices between linear and digital circuits.

  • Electrical Circuits with Bulbs

    57889 Electrical Circuits with Bulbs See attached file for full problem description. 1. In the circuit shown, the battery supplies 0.50 A of current. The current through bulb A is 0.15 A. Find the current through bulbs B and C. 2.

  • Circuit Analysis

    The autotransformer has just one winding that has three electrical connection points called taps. One tap forms a common connection that is connected to both the source and the load.

  • Matlab plots for input and output V

    See attachments Two electrical engineering problems -- For given circuits, input and output signals are plotted.

  • Solving electrical circuits using Superposition.

    circuits using the superposition

  • Working with Electrical Grounding and Polarity

    Thank you in advance Matt A ground is defined as a low-impedance electrical connection to earth. Also a common reference point in electronic circuits.

  • 7 Physics questions: resistance, power, current, series

    Calculate the electrical power of a lamp that carries 2 amps of current at 120 volts. 3. A heater uses 20 amps when connected to a 100-volt line.

View More Related Solutions