Purchase Solution

Power-flow problem

Not what you're looking for?

Ask Custom Question

Consider the electric power system shown {see attachment}. The power-flow solution of this system can be obtained without resorting to iterative techniques. The elements of the bus admittance matrix Ybus have been calculated as: {see attachment}.

Calculate the phase angle {see attachment} by using the real and reactive power equations at bus-3 (load bus).

See attached file for full problem description.

Purchase this Solution
Purchase this Solution
Free BrainMass Quizzes
Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

Air Pollution Control - Environmental Science

Working principle of ESP

View More Free Quizzes
Related BrainMass Solutions

  • Turbine fluids problem

    This is an example of a fluids problem regarding flow velocity, flow rate, mass flow rate, pressure, density, horsepower, power output, and efficiency of a turbine.

  • Power required to drive the compressor

    387173 Power required to drive the compressor Please help with the following problem. Please provide step by step calculations.

  • Representative velocity profiles

    Best regards Ricardo Alonso This solution explains in 170 words how the Blasius 1/7 power law can be used to find the velocity of flow in a system.

  • Pump behavior analysis

    Reference: Coulson and Richardson, Chemical Engineering, Vol 1 To do this problem, you need to know well the affinity laws, which enables calculation of flow, head, total power and NPSH when changes are made to both impeller diameter and pump speed

  • Heat Exchanger (Condenser)

    5977 Heat Exchanger: Condenser Please see the attached file for the fully formatted problem(s). Steam is condensed by cooling water in the condenser of a power plant.

  • Gear pump volume and pressure difference

    Thus, the pump actual flow rate equals to the theoretical flow rate which is Overall Pump Efficiency The overall efficiency of a pump equals output power divided by input power: Where = pressure difference across the pump = pump

  • Physics Virtual Circuits: Power of a Bulb

    How much current would flow? Determine how much power the bulb would radiate? (probably too little for a person to detect). Use you own calculations for this question. The lab can be used to test your results by comparing a similar model. 2.

  • Power generation turbines and solar panels

    To tackle this problem you need to find the x,y co-ordinates (the current & voltage values) for each point on the IV characteristic representing X,Y & Z.

  • Rate of heat supplied from a pump

    (b) Assuming the air in the heat exchanger acts as a heat sink having an average temperature of 25°C, determine the minimum power supplied to the heat pump, in kW. See attached file for full problem description.

View More Related Solutions