Purchase Solution

Introduction to Manufaturing Process - Question 4

Not what you're looking for?

Ask Custom Question

4) A flat bar is to be rolls but the rolls refuse to bite (the bar is not drawn into the roll gap). State at least two measures that could be taken.
(ISBN 0-07-116911-3) (chapter 9)

Purchase this Solution
Solution Preview

1. A good quality oil-in-water type emulsifiable fluid can be used for cold rolling of mild steels and medium ...

Purchase this Solution
Free BrainMass Quizzes
Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

Air Pollution Control - Environmental Science

Working principle of ESP

View More Free Quizzes
Related BrainMass Solutions

  • Introduction to Manufaturing Process - Question 5

    41038 Introduction to Manufaturing Process - Question 5 5) List at least three processes by which a plastic sheet of 2-m width and 0.2-mm thickness can be made. (ISBN 0-07-116911-3) (chapter 14) 1. Extrusion 2. Continuous Casting 3.

  • Introduction to the Manufacturing Process of Melting Casting

    41035 Introduction to Manufaturing Process - Question 2 2) Under otherwise identical conditions, would a melt heated to 1.2TL give a finer-grained casting than one heated to 1.1 TL? Give two reasons for your answer. (0-07-116911-3) No. 1.

  • Introduction to Manufaturing Process

    41036 Introduction to Manufaturing Process 3) A gear blank has been successfully hot forged on a mechanical press in a closed die. At the beginning of a new production run, the die burst. What is the likely cause?

  • Total Contribution Margin for Porter Company

    Direct Labor 82,500 Variable manufacturing overhead 81,000 Direct materials 91,500 Total manufacturing cost 350,000 Gross Margin = $450,000 The solution explains how to

  • Predetermined Manufaturing Overhead Rates

    306221 Predetermined Manufaturing Overhead Rates A company has two Departments, X and Y. Manufacturing overhead is allocated based on direct labor cost in Department X and direct labor hours in Department Y.

  • Operations - Capacity utilization

    Third, the question does not give us Team Net worth's process diagram to make comparison and decide where Magna went wrong.

  • Variance calculation

    b. the fixed overhead budget and volume variances for the year. 4. Total the variances you have computed, and compare the net amount with the $34,110 mentioned by the president.

  • Marketing Sample Quiz

    Question 4 Concerning the product life cycle: a.profits and sales begin to decline in the maturity stage. b.individual products may enter and leave the market at any stage.

  • Business Operation Management - Process Improvement

    Answer to Question 4: A's late start is 5 (please see attached file) =================================================== Question 5: The cycle time for each stage of a 4 stage process are as follows: Stage 1 = 10 seconds; Stage 2 = 20 seconds; Stage

View More Related Solutions