Purchase Solution

Current to Voltage Op Amp Circuit

Not what you're looking for?

Ask Custom Question

A 12-bit DAC (Digital to Analogue Converter) gives an output range of 0
to ââ?¬"1 mA for a digital input word of 0 to 4095. The required output,
however, is for a bipolar voltage range of Ã?±5 V.

(a) Design a current-to-voltage converter circuit to achieve the required
bipolar output voltage.

Purchase this Solution
Solution Summary

This posting contains the solution to the given problems.

Solution Preview

Hi,

Please see attached for the solution to the following problems.

Hope this helps ...

Purchase this Solution
Free BrainMass Quizzes
Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

Air Pollution Control - Environmental Science

Working principle of ESP

View More Free Quizzes
Related BrainMass Solutions

  • Op Amps

    Input offset voltage is the differential DC voltage needed to be applied between the inputs of the op-amp to force the output of the op-amp to 0 volts.

  • Op-Amp Circuit

    This solution finds the voltage for an op-amp circuit.

  • Effects of Biasing Current and Offset Voltage to Op-Amps

    244922 Effects of Biasing Current and Offset Voltage to Op-Amps The circuit to the problem is a non-inverting amplifier with a resistive-network feedback.

  • Find the output voltage of the circuit with op-amp

    voltage of the circuit with op-amp.

  • Output voltage in Amps

    Assuming an ideal op-amp: Vin = 3V case: Remember that no current enters or leaves the op-amp First, lets consider what the voltage at the output of the op-amp will be. I'll call this Vo (not to be confused with Vout).

  • Op-Amp

    How would you increase the output current of an op-amp? 3. Describe two ways to fix the output voltage offset of op-amps? 1. The instrumentation amplifier has more than one stage because it is used for accurate measurements.

  • Real Op Amp

    155366 Real Op Amp 6. A real op amp is modeled by an ideal op amp, input bias current sources and an input offset voltage source. Given V10 = 10 mV, Ib1 = Ib2=Ib= 100 nA and R= 100 kilo-ohms a.

  • Using a Ladder Network

    Simplify the circuit as much as possible, and use Kirchhoff rules to obtain the voltage on that resistor. Remember the second golden rule: There is no current going into the op-amp. If you get stuck, you can always look at my solution.

  • Simple OP amp circuits with feedback

    amp circuits with feedback, one question concerns a 4 bit DAC utilising an opamp circuit, the other question analysis of potentiometer negative feedback op-amp circuit

  • OP AMP DC Voltage Analysis (ideal Op Amp Assumption)

    An analysis of 2 op amp circuits in terms of DC Voltage derivations assuming Ideal Op Amp conditions exist

View More Related Solutions