Purchase Solution

Sequence generator circuit using JKs.

Not what you're looking for?

Ask Custom Question

The circuit outputs at the start are set to Qa=Qb=Qc='0'. C is the MSB ant the output number at the start is therefore 0. Assume that each JK has a zero propagation delay.

Draw all the output waveforms, determine the sequence of output numbers produced by the JKs for eack clock cycle.

See attached file for full problem description.

Attachments
Purchase this Solution
Solution Summary

The solution draws the output waveforms for the circuit shown.

Solution Preview

Please see attached file.

JK Flip flops switch their state when J=K=1, and in this case when the clock pulse falls from "1" to "0".
Also, in this case, ...

Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science

Working principle of ESP

Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

View More Free Quizzes
Related BrainMass Solutions

  • A CRC is constructed to generate 4-bit FCS for an 11-bit message. The generator polynomial is X4 + X3 + 1.

    The generator polynomial is X4 + X3 + 1. A) Draw the shift register circuit that would perform this task b) Encode the data bit sequence 10011011100 (leftmost bit is the least significant) using the generator polynomial and give the code word.

  • Two D-Type Flip-Flop Questions

    Problem 2: Using positive edge-triggered D-type bistables with clear and preset terminals design a 3-bit synchronous sequence generator to give the following continuous sequence: 4,2,5,6,3,1,4 ... ... ...

  • J-K Flip-Flops

    46725 J-K Flip-flops Using negative edge triggered J-K flip-flops, design a 3-bit synchronous sequence generator to generate the following sequence: 0,1,3,6,0..... 1.

  • Electrical Energy Conversion: Synchronous Generator

    It is known as equivalent linear open-circuit characteristic. It is a straight line because it is a equivalent linear characteristic and no saturation effect is included. This line can be constructed using two methods: (1).

  • Flexible Budget Fall 2009 - JKS Manufactures

    283079 Flexible Budget Fall 2009 - JKS Manufactures JKS manufactures a single product that sells for $60 each. JKS's static budget estimated that 1,200 units would be produced and sold this past month.

  • RLC values in an AC circuit

    603662 RLC Values in an AC Circuit A series RLC circuit has R=150 ohm, L=500 mH, C=30 uF is connected to a signal generator, whose output frequency is adjusted to 100 Hz and the averaged output voltage is 10.0V (a) Calculate the impedance Z of the circuit

  • Physics

    b) Determine the frequency of the coils's rotation when the peak emf of the generator is 180V. 2. A series RCL circuit is a resonance and contains a varible resistor that is set to 175 ohms. The power delivered to the circuit is 2.6 W.

  • RL circuit

    53196 Given an RL circuit, find the rms voltage and current. 7. An RL circuit consists of a resistor R = 63 ohms , an inductor, L = 45 mH, and an ac generator with a rms voltage of 120 V.

  • Electromagnetism problems

    When the circuit is connected to a voltage generator with a different frequency, the ratio of the inductive reactance to the capacitive reactance is observed to be 7.19. What is the frequency of the generator?

View More Related Solutions