Calculating input impedance

Related BrainMass Solutions

• Calculating voltage gain and input impedance

  19667 Calculating voltage gain and input impedance See the attached. With switch S closed, the + terminal is grounded and so we have a "virtual ground" or short circuit at the input.

• Circuit Analysis - Calculating Voltage

  Find the values for the input impedance R_i, output impedance R_o, and small signal transcouductauce g_m. 4. Find the value of the small signal voltage gain. 5.

• BJT Circuit

  343937 Calculate Input and Output Impedance With base grounded, calculate d) Input impedance at the emitter. e) Output impedance at the collector. f) Output impedance at the collector with a resistor R across the constant current source.

• Input Impedance

  152510 Input Impedance If we have a 600 ohm transmission line terminated with a 1200 ohm resistor, how long must the transmission line be if the input impedance is purely real? What is the input impedance? Please see the attached file.

• Impedance and frequencies

  73348 Impedance and Frequencies In the circuit shown in Figure P6.9 (in the attached file), if L = 190 mH R1 = 2.3 kΩ R2 = 1.1 kΩ C = 55 nF a) Determine how the input impedance behaves at extremely high or low frequencies.

• Problem Feeder - Transformer

  (c) Compute the power and reactive power input at the sending end of the feeder. Load: Pl = Vl * Il * (p.f.) 180,000 = 2320 * Il * 0.87 Hence, Load Current = Il = 89.2 Amps @ 30 deg. (Lead) Load Impedance = Zl = Vl/Il = 26 @ -30 deg.

• Determine Magnitude of Impedance

  Hence the effective input impedance Zin = R = 100 Ohms. Hence, either plot (a) or (c) should be the plot of Z.

• AC Circit analysis and max power transfer

  What is the output voltage (Vout) when the input voltage (Vin) = 10 V. 1. The load impedance should be the complex conjugate of the drive impedance for maximum power transfer, so Z(load) = 50 Ohms + j10 Ohms 2.

• Drawing Impedance Diagrams

  Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals.