tensile force and corresponding normal stress of a wire

Related BrainMass Solutions

• Current Electricity: Resistance and Resistivity

  294562 Current Electricity: Resistance and Resistivity Stretch That Wire A wire of initial length L0 and radius r0 has a measured resistance of 1.56 ohm. The wire is drawn under tensile stress to a new uniform radius of r = 0.420r0.

• Important information about Stress

  We have the general formula to find the stress of a material Stress = Force / Area Therefore, N/m2 This solution calculates stress on steel given its cross section and tensile force. The stress on the material is determined.

• Analysis of the mechanical properties of different materials

  way of saying this is that the Resilience is approximately the product of the yield strength and yield strain (stress/strain at the yield point for a material) divided by 2 Toughness of a material is the total energy required to force the material

• Tensile stress

  14383 Tensile Stress in a Bar of Steel A bar of steel 1 by 1½ in cross section and 6 in long is subjected to a pull of 6000 lb. What is the average tensile stress in the bar?

• Elasticity: Tensile stress - normal, tangential; shear stress

  with a plane at right angles to the bar. a.) What is the tensile (normal) stress at this plane in terms of F, A, and ? ? b.) What is the shear (tangential) stress at the plane in terms of F, A, and ? ? c.) For what value of ?

• Stress Due to Axial Force and Bending Moment

  As shown in the figure below, the shaft is subjected to an axial tensile load of 50,000 lbs. If the force P = 390 lbs, what is the combined stress at point A and point B. Indicate whether they are compressive or tensile.

• Tensile force formulas

  47666 Tensile force formulas A cylindrical steel beam is 2 inches diameter and 6 feet long. The modulus of elasticity is 30 x 1,000,000 psi. If the beam is subjected to a tensile force of 1000 lbs, what will be the resulting unit strain?

• Stress Analysis Sketches

  3) The tensile-type normal stresses will be assigned with "+" and the compression ones with "-". 4) The diameter of the small rod will be neglected The following notations will be used: normal stress caused by traction or compression

• Determine Stress on a Given Beam

   Since both stresses in the point (D) are of tensile type (that is positive), we will add them and the total normal stress will be: Therefore, the right answer is "a".