Purchase Solution

Output-input amplitude

Not what you're looking for?

Ask Custom Question

(See attached file for full problem description)

Consider the attached transfer-function system. Solve for the output-input amplitude ratio given the sinusoidal input.

Attachments
Purchase this Solution
Solution Summary

A solution that shows how to solve for an output-input amplitude ratio.

Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science

Working principle of ESP

Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

View More Free Quizzes
Related BrainMass Solutions

  • Alegebra & Complex Numbers : Amplitude Ratio and Input and Output Voltage

    63251 Algebra & Complex Numbers : Amplitude Ratio Make y the subject of the formula E = p(1-e^(y-1)) If the amplitude ratio, N in decibels is given by n = 10log(P0/P1) and the power is given by P=(V^2/R), show that for matched input and output resistances

  • Eigenfunctions and LTI systems

    This means that, if the input to a system is the complex waveform Ae^(st) for some complex amplitude A and complex frequency, (s), the output will be some complex constant times the input, say Be^(st) for some new complex amplitude B.

  • Transfer Functions of Simple Filters

    In the circuit shown in the diagram, R = 1 kOhm and C = 50 nF; at 10 kHz, the output signal amplitude equals Vout = 5 Vpk. Calculate the output signal amplitude at 50 kHz. Part 2.

  • Peak to peak triangle wave amplitude at the output

    Predict the peak-to-peak triangle wave amplitude at the output that would result from a 2Vpp 500 Hz square wave input. The reason this circuit is called an integrator is because it integrates the input value at the output.

  • Logarithims and Exponents

    141431 Logarithims and Exponents If the amplitude ratio, N in decibels, of an electrical system is given by the formula;- N=10log(Po [output]/Pi [input]) and the power is given by;- P=V^2/R Show that for matched input and output resistances

  • Switch resistance

    Suppose that the input sine wave has amplitude 5Vpp and the scope measures an output amplitude of 45mVpp. Estimate the Ron of the switch. (Note that when the switch is "ON", the output is "OFF"; don't confuse the two.)

  • Undistorted Sinusoidal Signals in a Diode Circuit

    Vs(t) = +9sin(wt) Amplitude of the output signal Vo.

  • Problem from Hykins Book

    If input is , output is 4.5. If input is , output is -0.5. If input is , output is -4.5. bits/sample Number of levels is equal to . , , , , Thus, the PCM waveform is 0100 0100 1100 1100 for .

  • Engineering Systems and Feedback

    - DC Gain= k = 1 since the output amplitude follows the input amplitude.

View More Related Solutions