NC Programming
Not what you're looking for?
Create an nc part program for making the slot shown in the attachment.The cutter diameter is 3/16 inch. The starting point is (0,0) at 2 inches to the left and 2 inches below the lower left corner of the part. There is also an example with a fully worked out solution included in the attachments. Write also the apt geometry and motion statements for the work part shown.
The other document is an attempted solution. You will have to modify it for me to obtain the nc part program solution.
Purchase this Solution
Solution Summary
The solution attached the finished NC Program as per requirements specified by the asker with some explanation.
Solution Preview
Hi,
I have modified the code you were presented with to fit the required solution. Please find it attached.
Modified solution:
Example G01
% (PROGRAM START FLAG)
:1002 (PROGRAM #1002)
N5 G90 G20 (BLOCK #5, ABSOLUTE IN INCHES)
N10 M06 T3 (TOOL CHANGE TO TOOL #3)
N15 M03 S1250 (SPINDLE ON CW AT ...
Purchase this Solution
Free BrainMass Quizzes
Architectural History
This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.
Air Pollution Control - Environmental Science
Working principle of ESP