Ideal vapor-compression refrigeration system

Related BrainMass Solutions

• Ideal vapor-compression refrigeration cycle

  17524 Ideal vapor-compression refrigeration cycle An ideal vapor-compression refrigeration cycle, with ammonia as the working fluid, has an evaporator temperature of -20c and a condenser pressure of 12 bar.

• An ideal vapor-compression refrigeration cycle uses R-134a

  101129 An ideal vapor-compression refrigeration cycle uses R-134a An ideal vapor-compression refrigeration cycle uses R-134a as the working fluid in an air-conditioning system.

• Refrigeration cycles

  The solution discusses a refrigeration system with a standard vapor-compression cycle and makes calculations to solve for required power, volume flow and vapor to volume ratio.

• Refrigerant 134a leaves the evaporator as saturated vapor at

  Coefficient of performance (COP): The COP of a refrigeration system is defined as the cooling effect per work input. Or: COP = Qevap/W We need Qevap, which is the heat exchange at the evaporator. You need to take note here: ?

• A large refrigeration plant is to be maintained at -15C

  Assuming the plant operates on the ideal vapor-compression cycle using refrigerant 134-a between the pressure limits of 120 and 700 kPa, determine 1. The mass flow rate of refrigerant 2. The power input to the compressor 3.

• A vapor-compression heat pump system

  45820 A Vapor-Compression Heat Pump System A vapor-compression heat pump system uses R-134a as the working fluid. The refrigerant enters the compressor at 0.24 Mpa, 0 degrees Celsius, with a volumetric flow rate of 0.6m^3/min.

• Refrigerant 134a enters a heat exchanger

  96614 Refrigerant 134a enters a heat exchanger in a steady state refrigeration system as saturated Refrigerant 134a enters a heat exchanger in a steady state refrigeration system as saturated vapor at 0 °F and exits at 20 °F with no change in pressure

• Thermodynamics: Adiabatic process, P-V graph, final P and T

  Show the compression on a PV diagram put in some numbers and label the axes. How much W is done during the compression ? The air may be considered as an ideal gas.

• Refrigerant R-134a vapor in a piston-cylinder assembly

  The work by refrigeration will be boundary work: Wb = P(v2 - v1) = Perform energy balance for the system: The solution provides step-by-step instructions, calculations and references for the problem.