Purchase Solution

Electric Heater

Not what you're looking for?

Ask Custom Question

The Problem: An electric heater is connected to a constant 250-V source and absorbs 1000 W. Subsequently, this heater is connected to a constant 210 V source. What power does it absorb from the 210-V source? What is the resistance of the heater?

Purchase this Solution
Solution Summary

This solution includes simple calculations and answers for the power and resistance of the electric heater.

Purchase this Solution
Free BrainMass Quizzes
Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

Air Pollution Control - Environmental Science

Working principle of ESP

View More Free Quizzes
Related BrainMass Solutions

  • Electric work and capacity of a conductor

    C = Q/V = 0.004/220 = 0.1818 F 2 ) A total charge of 300C circulates along an electric heater connected to 220V. Calculate the electric work performed by the electric power.

  • Lifecycle cost calculation and analysis

    Electric heater is more energy efficient as all the heat produced is used for heating purpose. Gas heater loses some of the heat which reduces its efficiency.

  • recovery time

    The unit is electric and utilizes a resistance heater (120 V ac, 3.0 ohms) to heat the water. Assuming that no heat is lost to the environment, what is the recovery time (in hours) of the unit?

  • Light, Frequency, Voltage and Current

    High voltage electric power lines produce EMF of 80 Hz. 2. An office worker wants to plug in a 3000 watt 110 Volt heater into a standard 15 amp, 110 V electrical outlet. Would this be safe? A.

  • An immersion heater

    276689 An immersion heater An immersion heater used to boil water for a single cup of tea plugs into a 120V outlet and is rated at 300W. What is the resistance of the heater?

  • Thermodynamics: Isochoric Process

    34779 Thermodynamics: Isochoric Process A 2-kW baseboard electric resistance heater in a vacant room is turned on and kept on for 15 min. The mass of the air in the room is 75 kg, and the room is tightly sealed so that no air can leak in or out.

  • Control of an electric heating system

    546056 Control of an electric heating system Attached is a drawing showing the block diagram of the control of an electric heating system.

  • Power and Energy

    When the heater is switched on, an electric current of 13A flows through its heating element and the temperature of the water starts to rise.

  • Energy Analysis Of Closed Piston Systems

    95820 Energy Analysis Of Closed Piston Systems A mass of 15 kg of air in a piston-cylinder device is heated from 25 to 77 degrees Celsius by passing current through a resistance heater inside the cylinder.

View More Related Solutions