Purchase Solution

Op Amp Problem

Not what you're looking for?

Ask Custom Question

Assume the following op-amp is ideal except for having a finite gain equal to (10^7)/(s + 10) and a slew rate of 0.02V/us. The input to the amplifier is an ordinary music signal with frequency range between 10 radian/sec to 3000 radian/sec and a maximum amplitude of 1V. Do you think the input signal will pass through the amplifies without distortion? Please justify your answer with calculations.

Attachments
Purchase this Solution
Solution Summary

This solution shows how to calculate the peak voltage output and maximum frequency in an attached Word document.

Solution Preview

For this problem, the peak output of Vout should be obtained.

Since the circuit configuration is a non-inverting amplifier, the equation to be used ...

Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science

Working principle of ESP

Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

View More Free Quizzes
Related BrainMass Solutions

  • Op-Amp Circuit

    5482 Find V for the op-amp circuit shown assuming an ideal Op Amp. Find v for the op-amp circuit shown assuming an ideal Op Amp. See attached file for full problem description. Please see the attached file.

  • Op Amps

    This circuit shows the effect of the input offset current to the op-amp output: Please refer to the attachment for the complete solution. This posting contains the solution to the given problem.

  • Effects of Biasing Current and Offset Voltage to Op-Amps

    This solution will help students solve related problems to op-amp circuits and also will also understand the possible effects to the output voltage when those offsets in op-amps exist in a system. The solution to the problem is attached here.

  • Problem on Op-Amp Small-Signal Circuit

    22105 Problem on Op-Amp Small-Signal Circuit Consider a non-inverting BiCMOS (CA3140) op-amp shown in image 3b.

  • An example of how to analyze a op-amp circuit

    21467 An example of how to analyze a op-amp circuit (i) The minimum recommended supply voltages for the 741 op-amp are V+=5V and V-=-5V.

  • Find the output voltage of the circuit with op-amp

    126893 Find the output voltage of the circuit with op-amp Problem 11.4 only. See attached file for full problem description. In the following circuit, you may assume that the op-amp is ideal. Find an expression for the output voltage v2(t).

  • Op-Amps and ICs

    For the op-amp in problem 2, determine the phase lag when f = f1. 4. The op-amp in figure 1 has a unity-gain bandwidth of 3 MHz and the RF = 100Kohms and Ri = 5Kohms. Find the bandwidth. 5.

  • Current in Op-Amp circuit

    5470 Find current for the op-amp circuit. Find current "i" for the op-amp circuit shown in the attachment, assuming an ideal Op Amp (operational amplifier).

  • Describe the characteristics of op-amp circuit

    The expert describes the characteristics of op-amp circuits. BJT op-omp and BiCMOS op-amp is compared.

  • Looking at feedback and some Opamp problems

    For the ideal op-amp the slew rate is infinity but for a practical op-amp like the 741 it is around 0.5V/us. Temperature dependent effects make a real op-amp like the 741 depart from ideal behavior.

View More Related Solutions