Purchase Solution

Binary symbols, analog signals, and PCM waves

Not what you're looking for?

Ask Custom Question

Problem 6. Figure P5.3 shows a PCM wave in which the amplitude levels of +1 V and -1V are used to represent binary symbols 1 and 0, respectively. The code word used consists of three bits. Find the samples version of an analog signal from which this PCM wave is derived.

(See attached files for full problem description)

Attachments
Purchase this Solution
Solution Summary

This solution provides a solution (with diagrams) for a question regarding binary symbols, analog signals, and PCM waves.

Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science

Working principle of ESP

Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

View More Free Quizzes
Related BrainMass Solutions

  • PCM and PAM

    PCM is much preferred over PAM because PCM is less sensitive to noise than PAM, and PCM only needs 2 discrete states when converting analog signals to digital signals. b.

  • Telephone channels and PCM analysis

    The analog voice signal voltage always lies between -1.0 V and + 1.0 V. a. Assuming that ADC is linear, what is the step size between quantization levels? b. The PCM signal is converted back to an analog waveform.

  • Information Technology - Analog and Digital Signals

    Analog signals are pulses or waves of sounds or signals that are transmitted by one device and received by another. Digital signals, though, are electronic transmissions that are sent in binary format (or 1's and 0's).

  • Nyquist Bandwidth

    Answer G.711 (PCM: Pulse code modulation) is an international standard and widely used in the conversion of analog voice signals for use in digital transmission networks.

  • Multiplexer and Synchronization Questions

    Determine the bandwidth required to support the multiplexer output for 10 analog voice signals digitized using standard PCM and a TDM multiplexer with an overhead of 10%. Assume a bandwidth efficiency of 2-bps/Hz. 3.

  • Converting Analog to Digital

    151375 Converting analog to digital What issues must we consider when converting analog to digital? GENERAL ====== Signals in the real world are analog: light, sound, etc.

  • Analysis of digitally sampled PCM audio signal

    The signal is sampled, digitized and recorded on magnetic tape as a PCM signal. a.

  • An accounting information system

    If graphed, analog signals are shaped as sine waves, while digital signals are square waves. Sound is analog, as it is always changing.

  • Advantages and Disadvantages of four primary types of LANs

    Identify the difference between analog and digital signals. Provide an example of a digital signal and an analog signal. Which type are you more likely to encounter? Why?

View More Related Solutions