Purchase Solution

Analysis of Satellite FDMA System

Not what you're looking for?

Ask Custom Question

Analysis of a satellite FDMA system in terms of carrier power, bandwidth, uplink/downlink frequencies and saturated power, See attachment.

Attachments
Purchase this Solution
Solution Summary

Analysis of a satellite FDMA system in terms of carrier power, bandwidth, uplink/downlink frequencies and saturated power are provided.

Solution Preview

Analysis of a satellite FDMA system in terms of carrier power, bandwidth, uplink/downlink frequencies and saturated power

Find attached solution, thanks

An earth station (E/S) transmits four separate signals at different frequencies to a GEO satellite through the same high power amplifier (HPA). The HPA has an output power of 240 W. The signals have different bandwidths and frequencies as shown in Table I below.
The saturated power output of the satellite transponder is 80.0 W and the transponder is operated with 3.0 dB output back off. The transponder down converts all received signals by 2.90 GHz.
In parts a, b and c of this ...

Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science

Working principle of ESP

Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

View More Free Quizzes
Related BrainMass Solutions

  • TV Video Signals

    Video signals occupy a bandwidth of 6 MHz and are stacked in frequency from 50 MHz to 656 MHz without guard bands. There are 100 video channels numbered 1 through 100. Is this system using FDM or FDMA? b.

  • A private data network is constructed by a company using a large gateway earth station

    Would you recommend FDMA or TDMA for the uplink from the VSATs to the GEO satellite? Well this could be either FDMA, TDMA or CDMA for the multiple access, although usually VSAT systems operate in TDMA mode.

  • Analysis of TDMA satellite transmission system

    435000 Analysis of TDMA satellite transmission system This question uses part of the FDMA question that has also been assigned (#434455).

  • Radio Systems

    305678 Multiple access technologies FDMA, FDMA and CDMA. In design of radio systems that incorporate wireless networks, considerations must be taken such as user access, transmission direction, switching and signal strength.

  • Microwave line of sight link transmits signal a distance

    The gain of the antennas must be increased when the TDMA system described in part (d) is used because the bit rate is higher than with FDMA and the noise power in the receiver is therefore higher.

  • Radio Networks

    The RF channels have a bandwidth of 30 kHz. Modulation is FM with analog voice signals. Is this a FDM or FDMA system? Does it have fixed access or demand access? b. One channel is reserved for random access: Why? c.

  • Inventory problems:EOQ, ABC analysis

    Here is a sample of some items stocked, along with the annual usage of each item expressed in dollar volume. Use an ABC inventory analysis.

  • Relative Initial Speed Calculated

    a) Calculate its initial speed b) Calculate the initial energy of the satellite-Earth system c) Calculate the energy of the satellite-Earth system after the collision d) Explain why the satellite loses altitude and spirals into the Earth after the

  • Structured Wiring

    Explain the differences and similarities between a loop start system and a ground start system. Explain the role of satellite communications in the wireless world. The rationale for structured wiring is that it increases the speed.

View More Related Solutions