Purchase Solution

Maximum Voltage Applied

Not what you're looking for?

Ask Custom Question

A resistor as a resistance of 100kilohms and a power rating of one-quarter watt. What is the maximum voltage that can be applied across it?

Purchase this Solution
Solution Summary

Brief calculation show the maximum voltage a given resistor can handle. A power rating of one-quarter watts are examined. The maximum voltage that can be applied across it are determined.

Purchase this Solution
Free BrainMass Quizzes
Variables in Science Experiments

How well do you understand variables? Test your knowledge of independent (manipulated), dependent (responding), and controlled variables with this 10 question quiz.

The Moon

Test your knowledge of moon phases and movement.

Basic Physics

This quiz will test your knowledge about basic Physics.

Intro to the Physics Waves

Some short-answer questions involving the basic vocabulary of string, sound, and water waves.

Classical Mechanics

This quiz is designed to test and improve your knowledge on Classical Mechanics.

View More Free Quizzes
Related BrainMass Solutions

  • Transformer Regulation / Efficiency

    When carrying rated current with the low voltage terminals short-circuited, the input power was 1.14kW, and the applied voltage 93V rms.

  • Circuits and Waveforms

    (a) Determine the maximum voltage drop along the ground conductor. (b) Sketch the waveform of the voltage which will appear along the ground conductor. (c) How would you reduce the ground conductor impedance in practical circuits?

  • Alternating currents

    33719 Alternating currents An emf of 10 V maximum and frequency 20 Hz is applied to to a 20uF capacitor. Find (a) 1 sub max and (b) I sub rms. The main difference between an alternating current and a DC is in their production.

  • Starting and maximum torque for wound rotor induction machine

    A 3 phase, 50 Hz, 6 pole wound rotor induction machine has the following per phase parameters: Rs = Negligible Ls = 0.003 H Rr = 0.3 Ohm Lr = 0.002 H Lm = 0.1 H Rc = Infinity Ns/Nr = 1.2 The voltage applied to each phase is 240 Vrms

  • NMOS FET and BJT analysis

    The NMOS FET, or the MOSFET in general, has its drain current reach a maximum value independent of increasing drain to source voltage because a MOSFET has a fixed sized channel at a certain amount of bias applied to the gate.

  • calculate the maximal charge

    The maximum voltage that can be applied: 15x10^6 V/m*(0.1*10^-3m)=1.5x10^3 V (Dielectric Breakdown in silicone oil is 15 MV/m) Q=CV=11x10^-9*1.5x10^3=1.65x10^-5 C.

  • impedance, capacitance, and indcutance

    137216 Voltage, Impedance, Capacity and Inductance. See attached file for full problem description. 1. An ac voltage at 1000 Hz is applied to a resistor and an inductor in series.

  • Amplifier Design

    vi) Output voltage swing must be at least 2 V p-p. (That is, the output voltage must have room to swing by +- 1V from the Q-point. vii) Does not exceed any of the maximum ratings on the transistors.

  • Frequency Modulation

    t) is applied to a 100 Æ'¶ antenna. What is the transmitted power? 6. The maximum deviation in broadcast FM is 75 kHz. Suppose that a commercial FM system has modulating frequencies 40 Hz to 20 kHz.

View More Related Solutions