Purchase Solution

Finding voltages at opamp terminals from circuits

Not what you're looking for?

Ask Custom Question

FIGURE 1 shows two amplifier circuits, each of which has one unknown
voltage (shown highlighted).Assume that
the op-amps are ideal and that the magnitude of their output voltages is
less than their maximum peak output voltage swing (VOM).

See attached.

Attachments
Purchase this Solution
Solution Summary

This solution shows how one can determine the input potentials at opamp terminals by considering Ideal OpAmp conditions and circuit topology, including kirchoffs current law, potential divider law and virtual earths

Purchase this Solution
Free BrainMass Quizzes
Variables in Science Experiments

How well do you understand variables? Test your knowledge of independent (manipulated), dependent (responding), and controlled variables with this 10 question quiz.

Classical Mechanics

This quiz is designed to test and improve your knowledge on Classical Mechanics.

Intro to the Physics Waves

Some short-answer questions involving the basic vocabulary of string, sound, and water waves.

Basic Physics

This quiz will test your knowledge about basic Physics.

Introduction to Nanotechnology/Nanomaterials

This quiz is for any area of science. Test yourself to see what knowledge of nanotechnology you have. This content will also make you familiar with basic concepts of nanotechnology.

View More Free Quizzes
Related BrainMass Solutions

  • Comparing current from the battery

    How does the current from the battery compare when the switch is open (and has been open for at least five minutes) and when the switch is closed (and has been closed for five minutes) in each of the circuits below? Explain.

  • Voltage Output Circuits

    And it will clip, because an opamp can't put out more than its "rails" (the power supply voltages) which are +/- 12 here. So whenever the input exceeds +/- 6 V, the output will clip.

  • Looking at feedback and some Opamp problems

    All practical op-amps depart from ideal behavior and have a large but finite input impedance looking into the input terminals of the op-amp.

  • Multistage Amplifer

    Due to the nature of components being not ideally identical, there will be some offset voltages produced during amplification. The Offset null terminals are usually placed by a certain value of resistance to eliminate the offset voltage.

  • Finding appropriate source for the electrical load

    The voltages are analyzed.

  • Circuit analysis with LEDs, BJTs, Relays, Opto Couplers

    Assumptions: Logic '1' = V Logic '0' = V Transistor forward current gain hfe = LED current = 10 mA LED voltage drop at 10 mA = V Base/emitter voltage = V Collector emitter voltage when transistor is on = 1 V External Terminals

  • Thevenin's theorem, Norton's theorem circuits, networks

    c) Thevenin's (Norton's) Resistance The Thevenin(Norton) resistance r is the resistance seen at terminals AB with all the voltage sources replaced by short circuits and all the currents replaced by open circuits.

  • OP AMP DC Voltage Analysis (ideal Op Amp Assumption)

    FIGURE 1 shows two amplifier circuits, each of which has one or two unknown voltages (shown highlighted). Select, from TABLE A, the most appropriate value for the unknown voltages for each circuit.

  • Understanding capacitors and inductors

    1.In practice, most digital circuits such as microcontroller circuits are designed as direct current (DC) circuits. It turns out that variations in the voltages of these circuits can cause problems.

View More Related Solutions