Voltage for circuit

Related BrainMass Solutions

• Electrical circuit analysis

  331813 Electrical circuit analysis Find the Thevenin equivalent voltage and current for the network shown in Figure 1-2 if V1 = 6V, R1 = 4 Ohm, R2 = 8 Ohm. Also find the Norton equivalent circuit to Figure 1-2.

• Thevinin Equivalent to Work out max Power

  Could I please get someone to write down the equation for working out the ZTH(Thevinin equivalent load for this circuit) also could you find Vab1 is the voltage of the circuit using the voltage source and open circuit current source and applying the voltage

• Potential divider and its Thevenin's circuit.

  For any load RL connected parallel to R2 the current and hence the voltage across R2 will decrease. For very high resistances the decrease in the voltage across R2 (supply voltage) will be very small.

• LCR Circuit - finding currents and voltage

  The expert finds currents and voltage for an LCR circuit.

• Graph source and load voltage of a circuit

  The correct sketch of the source voltage and the load voltage vL(t) as a function of time will then be: Please show the source voltage in solid and the load voltage in dashed See attached file for full problem description.

• Series and Parallel Circuits Analogy

  To measure the voltage and the current across the two circuits, you will use voltmeter for voltage and Ammeter for current. 6. To measure voltage in series circuit, check the voltmeter box on the right hand side and a voltmeter appears.

• RL circuit

  (a) At what frequency will the rms current in this circuit be 1.5 A? (b) For this frequency, what is the rms voltage across the resistor, Vrms,R?

• Multisim Circuit

  Design a Multisim circuit using an LM339 that turns on "Fuel Level" indicator lamp when the voltage level from the sending unit gets below 0.5V. Please see attached files for the circuit of the fuel-level detector.

• Thevenins Therom

  Thevenin's Theorem for electrical networks states that any combination of voltage sources, current sources, and resistors with two terminals is electrically equivalent to a single voltage source V and a single series resistor R.

• AC-LCR Circuits: Inductance, Capacitance and Frequency

  For the same voltage the current is given by where f is the face different and Z is the impedance of the circuit. The impedance of the circuit is given by here XL and Xc are inductive and capacitive reactance.