The Tevenin and Norton equivalent circuit

Related BrainMass Solutions

• Norton Equivalent Resistance

  Answer: B The Norton equivalent impedance and Thevenin equivalent impedance are the same and can be found in similar fashion. In this case the current source is replaced by an open circuit and the impedance at terminals a-b is found.

• Circuit Analysis of Three Elements

  The Norton Equivalent Circuit is determined.

• The Norton equivalent and superposition

  (5) Find the Norton equivalent (R_N and I_N) at terminals a-b of the circuit shown below (6) Using superposition, calculate v0 in the circuit below (7) Find the Norton equivalent (R_N and I_N) at terminals a-b of the circuit shown below Please

• Norton Equivalent Equation

  81011 Norton Equivalent Equation For the attached circuit, calculate the Norton Equivalent circuit at terminals a-b. a. Isc = 2.0 < 0.0 A b. Isc = 3.0 < 0.9 A c. Isc = 2.0 < -2.0 A d. Isc = 3.0 < -3.0 A Please see the attached files.

• Norton's Theorem

  81023 Calculate the Norton equivalent circuit Calculate the Norton equivalent circuit at terminals a-b for the attached circuit. See attached file for full problem description. Please see the attached file.

• Electrical circuit analysis

  331813 Electrical circuit analysis Find the Thevenin equivalent voltage and current for the network shown in Figure 1-2 if V1 = 6V, R1 = 4 Ohm, R2 = 8 Ohm. Also find the Norton equivalent circuit to Figure 1-2.

• Thevenin's theorem, Norton's theorem circuits, networks

  The value of r is the same as that in the Thevenin equivalent and the current i can be found by dividing the open circuit voltage by r.

• Norton and Thevenin Equivalent

  495099 Norton and Thevenin Equivalent Please see attached. Given the one-port network. The output port of the one-port is defined by terminals A and B. a) Find the Thevenin and Norton Equivalent circuits.

• Solving for Thevenin Equivalent Resistance

  33842 Solving for Thevenin Equivalent Resistance Question: Find the Thevenin equivalent resistance seen by resistor R3 in the circuit. Compute the Thevenin (open-circuit) voltage and the Norton (short-circuit) current when R3 is the load.