Purchase Solution

Digital Signal Processing - Resulting Frequency Response

Not what you're looking for?

Ask Custom Question

(a) Design a lowpass FIR digital filter using "remez" routime in Matlab for the following specifications:
filter duration = 15 (order 14),
passband = [0.0, 0.4], stopband = [0.6, 1.0],
sampling rate = 2.0,
magnitude desired = [2.0, 0.0] (passband, stopband),
equal weight of deviation.
List any noticeable features that you observe about the filter coefficients.

(b) Remove even samples in the filter obtained in (a) and plot the resulting frequency response.

Purchase this Solution
Solution Summary

A Matlab script is attached and a short explanation is given for the solution.

Solution Preview

Hi,

I have attached the Matlab script. You should be able to run it and check the result.
The 1st figure shows you the ...

Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science

Working principle of ESP

Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

View More Free Quizzes
Related BrainMass Solutions

  • Digital to Analog Translation: Advantage of Schemes like QAM

    167788 Digital to Analog Translation: Advantage of Schemes like QAM Digital signals can be translated to analog signals by using relatively simple techniques such as varying the amplitude or frequency between two specified values.

  • DSP analog filter problem

    22584 DSP analog filter problem This problem is taken from the Textbook 'Digital Signal Processing using MatLab' by Ingle/Proakis. The below system (in the attached file) acts as an analog filter.

  • Sampling frequency and bit rate of transmission

    The resulting PAM signal is converted to 6 bit digital words with an analog to digital converter and the words are transmitted serially over a twisted pair used as the cable for data transmission. a. What is the sampling frequency? b.

  • FIR Filter Using Parks-McClellan Algorithm

    The problem is taken from 'Digital Signal Processing using Matlab' by Ingle/Proakis. 1. A digital signal y(k) contains a sinusoid of frequency π/2 and a zero mean unit variance Guassian noise w(k), i.e.

  • Applications of Fourier transform

    • Image processing to remove periodic or anisotropic artifacts such as jaggies from interlaced video, stripe artifacts from strip aerial photography, or wave patterns from radio frequency interference in a digital camera.

  • Digital Signal Processing and maintainability engineering

    631335 Digital Signal Processing and maintainability engineering Note; Please see attachment for more clarification. TQEM 1: Digital Signal Processing (DSP) 1.

  • Solutions of posed Qs on ADC, Sampling and Transmission

    The audio signal is sampled at 32 kHz and transmitted as a serial bit stream. If no additional bits are added, calculate the bit rate of the resulting digital signal. c.

  • Modulating Radio Frequency Carriers to Carry Digital Data

    There exists many types of AM depending on whether the modulating signal is analogue or digital in nature and the bandwidth used (2) The frequency of the carrier can be shaped or modified by the modulating signal to convey information.

  • Analysis of digitally sampled PCM audio signal

    The audio signal is sampled at a frequency of 50 kHz and converted to a serial bit stream using a 12 bit analog to digital converter (ADC). What is the bit rate of the digital signal that is recorded on the magnetic tape? c.

View More Related Solutions