Electronic Communications
Not what you're looking for?
1. A microwave system requires a +4-dBm audio level to provide 100% modulation. Determine the voltage level required if this is a 600 ohm audio system.
2. Determine the noise produced by a 500 ohm resistor at 26 degrees Celcius over a 2 MHz bandwidth.
3. Consider an amplifier with an output of 2 mV rms and noise 0.76 mV rms. What is the signal to noise ratio? Express it as an absolute ratio and in dB.
4. Suppose that a series RLC circuit has R = 25 Ohm, L = 2 mH, and C = 0.8 microF. Compute the resonant frequency in kHz.
5. A filter has a bandwidth of 20 kHz and a peak output at 300 kHz. What is Q?
6. Calculate the percent modulation if the maximum p-p carrier in V is 200 and the minimum p-p is 40 V.
7. A 750 W carrier is modulated at an 85% level. Find the total transmitted power.
8. Consider a spectrum analyzer and suppose that V1 = 5 V, V2 = 0.1 V, V3 = 0.4 V, and V4 = 0.2 V. What is the total harmonic distortion?
9. For a certain AM signal, the fundamental is 3 V. If a harmonic at 4 kHz is 0.07 V, what is the relative harmonic distortion?
10. A 1 MHz 40-V peak carrier is modulated by a 5-kHz intelligence signal so that m = 0.7. This AM signal is fed to a 50 Ohm antenna. Calculate the power of each spectral component fed to the antenna.
Purchase this Solution
Solution Summary
This posting contains the solution to the given problems.
Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science
Working principle of ESP
Architectural History
This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.