Explore BrainMass

# Light Interference

Interference is a phenomenon in which two waves superimpose to form a resultant wave of greater or lower amplitude. Interference is usually referring to the interaction of waves that are correlated or coherent with each other. This is either because they come from the same source or because they have the same or nearly the same frequency. Interference effects are observed with all types of waves, light, radio, acoustic and surface water waves.

Due to the frequency of light waves being too high to be detected by current detectors, it is possible to observe only the intensity of an optical interference pattern. The intensity of light followed the inverse square law. The intensity of light is proportional to the square of the average amplitude of the wave. Therefore, the interference pattern maps out the differences in phase between the two waves with maxima occurring when the phase difference is a multiple of 2Ï€.

In order for two waves to give rise to interference fringes,  the waves must have the same polarization. This is so it is possible for waves of different polarizations to cancel one another out or add together. Instead, the waves of different polarization are added together and give rise to a wave of a different polarization state.

## BrainMass Categories within Light Interference

### Films

Solutions: 13

Thin-film optics is the study in optics that deals with thin structured layers of different materials.

### Double Slit

Solutions: 10

The double slit experiment shows that light displays both particle and wave like behaviors.

### Interferometers

Solutions: 0

Interferometry are techniques in which waves are superimposed in order to extract information about the waves

### Light & Interference

1. "7x50" binoculars magnify angles by a factor of 7.0, and their objective lenses have an aperture of 50 mm diameter. (a) According to Rayleigh's criterion, what is the intrinsic angular resolution of these binoculars? Assume that the light have a wavelength of 500 nm. (b) At best, the pupil of your eye has an aperture

### Outcome Measure and review of a section of literature review

Question #1 Give examples on how your outcome measure could be utilized for other research projects? Question #2 For this Utilization Review course we are conducting a needs assessment within our facility and writing a proposal to "fix" the issue found. My proposal is a training program within the Health and Longevity center

### Interference of light: Distance between fringes

A pair of narrow, parallel slits separated by 0.250 mm are illuminated by the green component from a mercury vapor lamp (wavelength= 546.1 nm). The interference pattern is observed on a screen 1.20 m from the plane of the parallel slits. Calculate the distance (a) from the central maximum to the first bright region on either sid

### Hypothesis, Literature review, research design: Biases and Judgments

See attached files. Part 1 For this assignment, use the same hypothesis and the Literature Review from your IP1 (Part 2) assignment and compose a theoretical framework (Step 4 of the Sekaran process). Use the components of a theoretical framework described in the Sekaran textbook as well as the examples contained in the

Conduct a systematic literature review to critically examine a mental disorder that occurs in adolescence. Examine the existing body of scientific evidence on diagnosis and treatment and provide a summary of the evidence that is theory driven and research based. The scientific review of the literature will identify the best prac

### How can multipath fading can be mitigated in a line of sight (LOS) link?

A microwave line of sight link has a single hop with the following parameters: Transmit power 5 W Transmit and receive antenna gain 38 dB Length of link 40 km Transmission frequency 10 GHz All losses 3 dB Rece

### Reflected Light and Interference Problems

Two Glass Plates (see attached file) Two glass plates are separated by fine wires, with diameters d1 = 0.0510 mm and d2 = 0.0530 mm, as indicated in the figure below. The wires are parallel and separated by a distance of L = 6.89 cm. If monochromatic light with lamba = 577 nm is incident from above, what is the distance (in

### Interference of Parallel Slits: Value of Lambda^2

A beam containing light of wavelengths lambda^1 and lambda^2 is incident on a set of parallel slits. In the interference pattern, the fourth bright line of the lambda1 light occurs at the same position as the fifth bright line of the lambda^22 light. If lambda1 is known to be 540 nm, what is the value of lambda^2? Please sol

### distance from the slits to a screen

Light of wavelength 468 nm falls on two slits spaced 0.287 mm apart. What is the required distance from the slits to a screen if the spacing between the first and second dark fringes is to be 4.34 mm? -Please solve and explain problem.

### Slit separation: interference pattern

Light with a wavelength of 551 nm passes through two slits and forms an interference pattern on a screen 8.54 m away. If the linear distance on the screen from the central fringe to the first bright fringe above it is 5.06 cm, what is the separation of the slits? -please solve and explain problem.

### Literature Review

This assignment is the continuation of the Unit 1 IP (Part 2) assignment and it has two parts for the Unit 2 IP assignment: Part 1 For this assignment, use the same hypothesis and the Literature Review from your IP1 (Part 2) assignment and compose a 2-3 page theoretical framework (Step 4 of the Sekaran process). Use the compo

### Newton's ring

The radius of curvature of the convex surface of a planoconvex lens is 95.2cm. The lens is placed convex side down on a perfectly flat glass plate that is illuminated from above with red light having a wavelength of 580 nm. Find the diameter of the second bright ring in the interference pattern.

### Determining Distance using Light Interference

Two slits are illuminated by a 621 nm light. The angle between the zeroth-order bright band at the center of the screen and the fourth-order bright band is 14.4 degrees. If the screen is 150 cm from the double-slit, how far apart is this bright band from the central peak? Answer in units of cm.

### Light Waves: Young's interference experiment

See attached file for full problem description. Young's interference experiment

### Combination lens and double slit interference

A source of monochromatic light with wavelength lambda is located on optical (principal) axis on distance p from converging lens, which consist of two pieces of different glass as shown in the figure. Parallel to the lens axis screen is D away from it (D>>p). Define lens focal length f and derive the expression for estimating th

### A Discussion On Converging Lens And Double Slit Interference

A source of monochromatic light with wavelength lambda is located in point A which is p away from some lens. Virtual image of A is in point A'. Parallel to line AA' screen is D away from it (see fig.). Define lens type (converging or diverging), its focal length f, and derive the expression for estimating the order of the bright

### Derive the expression for estimating the order of the bright fringes that can be expected on the screen at point A.

This is a unique problem involving thin lens and double slit interference. The object and the image act as double slit and form bright and dark fringes on a screen placed parallel to the principal axis. A source of monochromatic light with wavelength L is located on optical (principal) axis of converging lens with focal lengt

### Double slit interference and circular aperture diffraction

(1) (a) A double slit experiment is performed with 589 nm light and slits-to-screen distance of 2.00 nm. The tenth interference minimum is observed 7.26 mm from the central maximum. Determine the spacing of the slits. (b) If the slit is replaced by a circular aperture with a diameter equal to the spacing of the double slit

### Interference of Light: Contrast in Laser and Sodium Light

When a laser is used to illuminate a Michelson interferometer, we will see fringes with excellent contrast even when the two arms are a centimeter or more away from equal length. But when we use a sodium lamp as the light source, in place of the laser, fringes are visible only when we have extremely close to equal arm lengths.

### Discuss the advantages and disadvantages of using radio frequency (RF) communications vs. infra red (IR) communications.

Discuss the advantages and disadvantages of using radio frequency (RF) communications vs. infra red (IR) communications. Comparisons may include bandwidth, FCC regulation, interference, and eavesdropping.

### Fringe pattern from interference, waves of different lengths

Fringe Patterns. See attached file for full problem description. Suppose two mutually coherent plane waves with two different wavelengths, Î»1 and Î»2, which have corresponding wave number k1 and k2 and corresponding angular frequencies Ï‰1 and Ï‰2. Their wave vectors are confined to the x-z plane and their angles with resp

### Interference of Light: Difference situations

If you punched a metal plate with two pinholes and illuminated them with light, would you see interference fringes if you used: (a) laser light, or (b) light from an LED (light emitting diode) ? (c) sunlight ? (d) spontaneous emission coming out the side of the He-Ne laser ?

### Oil Film and Light Interference

Consider an oil film (n = 1.5) on water (n = 1.33) and light of wavelength 600 nm in air, incident of the film. What would the minimum film thickness for constructive interference of the light in air be?

### A new application of Newtons rings experiment

This experiment demonstartes a method to calculate the thickness of a thin film ( say a paper strip) using the phenomenon of interference.

### Constructive interference

Assuming that x is the wavelength of light in oil (they used a different variable but my PC cant reproduce that symbol), for an oil film on water, constructive interference occurs with the minimum film thickness of: a. 2x b. x/4 c. x d. x/2

### Reflection of light

"A thin layer of magnesium fluoride (n = 1.38) is used to coat a flint-glass lens (n = 1.61). What thickness should the magnesium fluoride film have if the reflection of 463 nm light is to be suppressed? Assume that the light is incident at right angles to the film."

### Double-slit interference pattern

Light from a He-Ne laser ( lambda = 632.8 nm) strikes a pair of slits at normal incidence, forming a double-slit interference pattern on a screen located 1.20 m from the slits. Figure 28-34 shows the interference pattern observed on the screen. What is the slit separation? Please see the attached.

### Interference and diffraction

What is the difference between interference and diffraction of light waves?

### Young's Double-Slit Interference

A riverside warehouse has two open doors, as in Figure P24.11. A boat on the river sounds its horn. To person A the sound is loud and clear. To person B the sound is barely audible. The principal wavelength of the sound waves is 2.80 m. Assuming person B is at the position of the first minimum, determine the distance between the

### Two glass plates in contact separated by a thread at one end where is the next dark fringe? At what distance from the contact point is the next dark fringe?

Two glass plates 10cm long are in contact at one end and seperated at the other end by a thread .050 mm in diameter. Light containing two wavelengths 400nm and 600nm is incident perpendicularly. At what distance from the contact point is the next dark fringe? Please show me the method step by step. Answer 1.2mm