Explore BrainMass
Share

# AC

An AC circuit is an alternating current circuit. Instead of a constant voltage supplied by a battery, the voltage oscillates in a sine wave patter varying with time.

V = V_0sin(wt)

Where

V_0 is the maximum voltage

W is the angular frequency

t is time

The first alternator to produce alternating current was a dynamo electric generator based on Michael Faraday’s principles. It was constructed by the French instrument maker Hippolyte Pixii in 1832. The earliest recorded practical application of alternating current is Guillaume Duchenne, inventor and developer of electrotherapy. In 1855, it was announced that AC currents were superior to direct current for electrotherapeutic triggering of muscle contractions.

AV voltage may be increased or decreased with a transformer; use of a higher voltage leads to significantly more efficient transmissions of power. The power losses in a conductor are a product of the square of the current and the resistance of the conductor.

P_L = I^2R

The power transmitted is equal to the product of the current and the voltage

P_t = IV

Therefore the same amount of power can be transmitted with a lower current by increasing the voltage.

http://www.magnet.fsu.edu/education/tutorials/java/pixiimachine/index.html

### Star Delta transformation of balanced 3 phase load

3. For the balanced three-phase loads shown in FIGURE 3, ZY = (15 + j15) Ω and ZΔ = (45 + j45) Ω. Determine: (a) the equivalent single Δ-connected load, (b) the equivalent single Y-connected load obtained from the Δ-Y transformation of (a) above, (c) the equivalent single Y-connected load obtained by transforming the Δ

### Two necessary conditions for oscillatory behavior of physical systems

There are at least two ways to describe the necessary conditions for oscillatory system behavior. Explain two of them. My thoughts: I've heard of using displacement as the variable and using angular movement as the variable, but I am having a hard time confirming this/visualizing this theory. Would someone be able to confirm

### Armstrong Oscillator with Secondary Winding's

See the attached file. The figure attached shows the Armstrong oscillator. A transformer with two secondary winding's has been use, one to give feedback and one to give the oscillator's output. Write a short report [two to three pages] on an investigation into the operation and performance of this circuit 1. The report sho

### Resistance of Aluminum Jumping Ring

Assume you have a solenoid with a diameter of 4.0 cm and 2900 turns per meter, with an impedance of 0.70. An iron core consisting of a bundle of wires is placed in the core. The core has an effective susceptibility of 10 (rather than 1000, for this is based on experimental results). An aluminum ring of a mass of 23 grams (1.4 cm

### Electric DC circuit is attached to a 12-volt battery

An electric DC ciruit is attached to a 12-volt battery and has a 3-ohm resistor in it. a. find the current flowing through the circuit. b. What is the current in an AC circuit with 120-volts and a 60-watt light bulb?

### LCR series parallel ac circuit with thevenin equivalent circuit

please see question Refer to figure 5-1 below a. Derive the Thevenin's equivalent e.m.f. and impedance as seen between the terminals AB. (Note:You must show the simplified version of the circuit that you are working on when applying the theorem). b. Draw the Thevenin's equivalent circuit derived in Part a. above, hen

### Current Values and Frequencies

A 30 mH inductor is connected in series with a 20 ohms resistor in an AC circuit. The voltage applied is fixed, V=50 V, and the frequency can be adjusted. At what frequency is the current in the circuit one-third of the value that exists when the frequency is zero?

### Determine the r.m.s. voltage of generator, and the power factor of the load.

In the circuit of FIGURE 2 (in the attachment), the generator V1 has a voltage of 120 volts (r.m.s.) @ 60 Hz and generator V2 has a frequency of 50 Hz. The load is represented by an inductor of 0.1 H and a resistor of 20 Ohms. (a) Determine the r.m.s. voltage of V2 if the reading on the ammeter, which reads true r.m.s., is to

### Circuits: AC/DC

A first-order RC high-pass filter has a cut-off frequency of fc = 2400 Hz and the capacitor value of C = 47 nF. What is the required resistor value? What is the ideal total current into the L and C branches of a parallel circuit at resonance?

### AC/DC Current Sources Required

If an input signal with v(t) = 10 sin ( 2 Ï? 1592 t + 0º ) is applied to a series RL circuit with R = 1000 ? and L = 0.1 H, what is the magnitude of the total circuit impedance? How many 100 mA current sources must be connected in parallel to produce a total current output of 300 mA?

### Comparison of AC & DC Power Generation

The US power distribution plant is considered by analysis the various circuit parameters of both AC and DC power plants to deliver 120V DC voltage to the end user. Using a simplistic approach it is shown that AC power distribution is far more cost effective and indeed safe over DC power generation systems delivering the same po

### Application of Kirchhoff's voltage law to two inductances connected in parallel.

FIGURE 4 (in the attachment) shows two inductances connected in parallel across an a.c. supply. (a) Apply Kirchhoff's voltage law to each loop of circuit. (b) Hence or otherwise obtain the current ratio I1/I2 in terms of the circuit inductances. (c) See if you can show that L1 and L2 can be replaced by

### Project Management and Frequency Updates of EAC and ETC

If a project has a history of issues, why would your management be so concerned about frequent updates to EAC and ETC?

### Analysis of a simple series capacitive circuit and problems

A series circuits consists of two capacitors C1 = 3 uF, C2 =6 uF connected in series with a DC supply of V(supply) = 6V (SEE ATTACHMENT FOR CIRCUIT). PART A: Determine the charge stored on C1 = 3 uF PART B: Determine the charge stored on C2 = 6 uF PART C: What is the voltage at point 1, the +ve side of C2?

### Alternating Current: Complex form of Ohm's law

A) Use the complex form of Ohm's law to show graphically that the voltage across an inductance L leads the current through the inductor by ninety degrees. b) Using the same method, determine the angle by which the voltage across a capacitor leads the current through the capacitor . (Complex numbers calculations are called

### Current Trends in Business Communication Paper

Write a paper that describes current trends in business communication. I have to address the following questions in your paper: o What role does business communication play in your day-to-day activities at work? How does it help you manage your daily work activities? o What trends have you seen in your curren

### Transformer's copper losses at full load, Transformer's efficiency

A. A small, mains, step-down transformer is used to power a 12 V apparatus. The transformer's rating label is attached. (i)Describe the constructional features of the transformer's core and explain why one winding is made of wire of a greater diameter than the other. (ii)The rating `T130' on the transformer's label refers

### Physics: Electricity and Magnetism; Properties of Light

See attached 7 circled questions. Note: figure not provided for question 40, and therefore no answer has been given.

### Alternating current circuits: Impedance of parallel circuit.

Calculate the magnitude of the impedance of the parallel combination of a 1K resistor, a 2K resistor, and a 15 micro Farads capactior when the frequency is f=5kHZ.

### Alternating current circuits: Power factor corrections

What size capacitor(s) is required to correct air conditioner system power factor from 0.63 to 0.99? Is it installed in series or parallel? (installed to switch with A/C cycle) Given: Load amps = 12 amps Voltage = 242 VAC main Meter power factor A/C off = .99 main Meter power factor A/C on = .63 Load is at the end of 300

### AC Circuits - Transformers

(a) A small mains step-down transformer used to power 12V apparatus has the label below: If the primary and secondary winding resistances are 125ohms and 0.7ohms respectively, calculate the transformer's copper losses at full load. (b) A large power transformer has a turns ratio N1/N2 of 1.5. When the primary voltag

### Physics: AC Circuits

(a) A particular 240V, 50Hz electrical appliance is rated at 2kW and has a lagging power factor of 0.7. (i) Determine the appliance's power factor when it is used on a 60Hz supply. (ii) Calculate the supply voltage required to maintain the appliance at its rated power when operated off a 60Hz supply. (b) When plac

Analogies describe complex subjects in a more meaningful and understandable way. For example, the difference between an analog and digital radio wave can be described using the following analogy: Imagine a person listening to a song on the radio; analog radio waves travel in a continuous, uninterrupted fashion just like the m

### Arc Waveform & AC Power

Please help with the following problem. This A) The difference of an ac waveform being displayed on an oscilloscope is of 6.5 volts between 90° point and the 270° one . What is the RMS value of the displayed signal ? b) What is the value of the ac power that can perform the same amount of work as a 24 dc

### Audio Source questions

A voltage from an audio source is: v(t)= 50sin(2764.6 t)mV A) What is the frequency of the source? B) If this voltage is applied to a 200 ohm resistance, what would be the formula for the current through it? C) What is the effective current, Ieff?

### Drawing off power by placing a loop below a transmission line

This figure shows a high-voltage 60-Hz power line in a remote area of the countryside. A local resident has erected a large open loop just below the line with the intention of drawing off power. Is this possible and, if so, how would it work? If not, why wouldn't it work?

### R L circuit phase angle

In the circuit shown (see the attached), the AC voltage source supplies an rms voltage of 115 V and the circuit has R1 = 3 kÙ and L = 34 mH. A) At what frequency will the rms current be 35.33 mA (milliamperes)? I was able to solve this part and got: f= 5914.33 Hz NEED HELP with the following (PLEASE EXPLAIN IN DETAIL)

### Nonvalue-maximizing behavior is most common

Simple questions on basic economics Question 1 Nonvalue-maximizing behavior is most common: in vigorously competitive markets. When shareholders are poorly informed. when managers own a significant ownership interest. in the production of goods rather than services. Que

### Addition and multiplication of sinusoidal waves.

Please see the 2 problems attached Q4.Two alternating currents i1 and i2 flow in a circuit node. The output current i is given by i1 + i2. If i1 = 5sin( 50t + &#61552;/3 ) and i2 = 6cos50t Calculate the amplitude of i and the first time that it occurs. Q5. The instantaneous power p, in an electric circuit, is giv

### Generators: Principle and Working

Generators How does it work? How does it apply or use magnetism? Which basic equation(s) govern its operation? Does this device have historical significance? If so, what is it? What do you envision as the future of this device? Can you imagine any other applications of the device?