Purchase Solution

A Three-Phase Overhead Transmission Line

Not what you're looking for?

Ask Custom Question

A three-phase overhead transmission line line has a per-phase resistance of 0.15 ohm/km and a per-phase inductance of 1.3263 mH/km. Assume that the shunt capacitance is negligible. The length f the line is 40 kilometers and it operates under 220 kV and 60-Hz. The line is supplying a three-phase load of 381 MVA at 0.8 power factor leading and at 220kV. Using the short line method calculate the sending-end three-phase complex power and the transmission line efficiency.

Attachments
Purchase this Solution
Solution Summary

This solution uses the transmission line per phase and the sending end of the line to calculate the transmission line efficiency. And annotated diagram of the short transmission line model and circuit equations are included.

Solution Preview

Please see the attach file. If you have any problem with my solution, please tell me.

40 km, 220 kV ...

Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science

Working principle of ESP

Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

View More Free Quizzes
Related BrainMass Solutions

  • Three-Phase Overhead Transmission Line

    32174 Three-Phase Overhead Transmission Line A three-phase overhead transmission line has a per-phase resistance of 0.15 ohm/km, and a per-phase inductance of 1.3263 mH/km. Assume that the shunt capacitance is negligible.

  • Modeling of a high-voltage transmission

    441629 Two Port Network is used to model the transmission line. Note: The Solution is handwritten. FIGURE 3(a) represents a 50 Hz, three-phase, high-voltage, transmission line.

  • Comparision of data rate of the transmission line and disk

    For what range of distances does Bernie have a higher data rate than a transmission line whose data rate (excluding overhead) is 150 Mbps? Capacity of each 8mm tapes = 7 gigabytes.                      

  • Transmission line

    Hence, net current as "seen" from any point along the line is zero. This is true for a three phase line also. The coil shown in the fig. will have induced emfs due to the forward AC current as well as the return Ac current.

  • Transmission Line

    332738 Phase change down the transmission line and the input impedance to the line Please show as much working as possible and comment where possible. (a) A transmission line has a length, l, of 0.4 lambda.

  • Fault Currents and Three Phase Faults

    So, the three-phase short circuit at bus 2 is Ia1 = -j 6.5 p.u. The solution looks at how to find the fault currents for a line to ground fault and a three-phase fault.

  • Electrical Power Systems Problems

    A three-phase line serves a 54MW load with a .9 lagging power factor at a line voltage of 138KV.

  • Characteristics of Transmission Lines

    b) what distance down the line can a voltage signal travel before it is reduced to 10% of its original amplitude. c) What distance must it travel to undergo a 90 degrees phase shift? Please see the attached file.

  • transmission efficiency of the High-Speed Digital Transmission System

    A) The number of voice channels that can be transmitted in the High-Speed digital transmission line is given by = (capacity of transmission line) / (Required bit rate for each channel) In the standard voice channel (PCM channel) the required

View More Related Solutions