AC Circit analysis and max power transfer

Related BrainMass Solutions

• AC Generator

  37748 AC Generator We have a AC generator that is attached to a resistor with 500 kohms and a maximum voltage of 90 V. How do you calculate Imax, max power, avg power, rms current, rms voltage, and frequency.

• The DC input power, heat generation and maximum thermal resistance of class A and B amplifiers are calculated, and the resulting numbers indicate that a Class A amplifier is an enormous power waster in comparison to a class B amplifier.

  We know that the AC output power is 200 Watts, and that the Class A and Class B amplifiers operate with the maximum theoretical efficiency.

• Comparison of AC & DC power generation

  384908 Comparison of AC & DC Power Generation The US power distribution plant is considered by analysis the various circuit parameters of both AC and DC power plants to deliver 120V DC voltage to the end user.

• Fourier analysis using Excel

  Once done click on "tools", then select "data analysis", then select "Fourier Analysis" from mthe drop down. You then need to select the input data range which needs to be a power of 2 sets of data points for this to work in Excel.

• AC Circuits - Transformers

  263572 AC Circuits - Transformers (a) A small mains step-down transformer used to power 12V apparatus has the label below: If the primary and secondary winding resistances are 125ohms and 0.7ohms respectively, calculate the transformer's copper

• Maximum volume

  (3): ab=ac, then b=c Therefore, a=b=c = 6/4/3 =0.5 m And V(max) = a*b*c=0.5*0.5*0.5=0.125 Cubic meter.

• Random Number Generator

  It means that ac+m >> max and so it will require a computer for a solution. The possibility of calculating variables from a random generator are discussed.

• Calculating Source Impedance for a Transformer for Max Power

  350975 Calculating Source Impedance for a Transformer for Max Power A large power transformer has a turns ratio N1/N2 of 1:5. When the primary voltage is 400 V and it is connected to a resistive load, its secondary current is 100 A.

• Diodes and Path of Current

  Finally, use the bridge circuit shown and design a DC power supply for a 12-V AC signal with a ripple voltage less than 0.4V. Sketch your circuit. Dear student, Please see the attached jpg scan.