Purchase Solution

Transducer, ADC, Bandwidth of system response

Not what you're looking for?

Ask Custom Question

Please see attachment for full question with diagram.

(a) Calculate the change in output code from the ADC for the transducer if the gap is changed from 500 micrometers to 600 micrometers.

(b) If the transducer was removed from the circuit what would be the DC offset voltage measured at the output?

(c) What is the bandwidth of the system response to changes in input gap?

Attachments
Purchase this Solution
Solution Summary

It does not calculate the values, however it gives various formulas and equations and briefly tells how these can be used to obtain the answers.

Solution Preview

Please see attachment.

Solution:

a)

C(transducer) = 0.008854 * A / d (1)
where A is the area, and d is the gap of transducer.

V(out) - V(in) = i(in) * ((R//(1/jwC)) (2)

i(in) = V(in) / (1/jwC(transducer)) ...

Purchase this Solution
Free BrainMass Quizzes
Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

Air Pollution Control - Environmental Science

Working principle of ESP

View More Free Quizzes
Related BrainMass Solutions

  • DSP Quantisation

    An analogue signal is to be sampled from a transducer with an output voltage range of 0 to 10 volts and operating on a 12-volt power supply. The designer has available two analogue to digital converters (ADC): a 3 bit ADC and a 4 bit ADC.

  • Digitizing an Audio Signal, PAM, ADC

    348319 Audio signal, Sampling frequency, Bit rate at the output of the ADC, Maximum bandwidth, Quantization SNR An audio signal has a bandwidth that extends from 100 Hz to 10 kHz.

  • Music signal transmitted over a digital radio link

    441907 Music Signal Transmitted Over a Digital Radio Link A music signal has a bandwidth of 50 Hz to 10 kHz.

  • 18 bit ADC thermal noise

    The ADC has a bandwidth of 1 MHz. Calculate the maximum value of Rn if the resolution of the ADC is not to be adversely affected by thermal noise. Assume the ADC operates at 25 degree C. [N.b.

  • Wheatsone bridge thermistor ADC

    The thermistor utilized in a Wheatstone bridge as a transducer, hence other resistances are estimated and potential difference across the bridge is estimated. This system is used as an input to a 12 bit ADC. Temperature change/bit is estimated.

  • Multiple electrical signal, level, noise calcualtions

    The ADC has a bandwidth of 1 MHz. Calculate the maximum value of Rn if the resolution of the ADC is not to be adversely affected by thermal noise. Assume the ADC operates at 25°C. [N.b.

  • Control of an electric heating system

    control of heating system with feedback system.

  • Advantages and disadvantages of using radio frequency

    the facility to eavesdrop on the system.

  • Examination of digital link and ISI

    362797 Root Raised Cosine (RRC) Filters, Inter Symbol Interference (ISI), Noise Bandwidth A digital communication system transmits binary data using polar NRZ pulses of current over a baseband link with a bandwidth of 20 kHz.

View More Related Solutions