Purchase Solution

Feedback Control Systems and System Specifications - Second Order Model

Not what you're looking for?

Ask Custom Question

Please see attachment for equation and graph.

Attachments
Purchase this Solution
Solution Summary

This solution is provided in 311 words. It describes the second-order system and uses a transfer function to find the solution to the problem.

Solution Preview

-------------
Feedback Control Systems and System Specifications
--------------------------------------------------------

From the diagram we get the following (approximately... I had to "eye-ball" some of these readings!)

A second-order system

Because of the overshoot, the system is probably "under-damped", but not a whole lot since there are not ...

Purchase this Solution
Free BrainMass Quizzes
Air Pollution Control - Environmental Science

Working principle of ESP

Architectural History

This quiz is intended to test the basics of History of Architecture- foundation for all architectural courses.

View More Free Quizzes
Related BrainMass Solutions

  • Control Systems Specifications

    47207 Control Systems Specifications Given P = 1/(s/3+1), obtain a second order model for T(Y/Di) (transfer of input disturbance to plant output with feedback) to satisfy the following regulating requirements for a step input disturbance of height 15

  • Feedback Control Systems - System Specifications

    . ---------------------------------------------------------------------- The feedback control systems and system specifications are given. The answers are given step-by-step with a short explanation.

  • Design a series controller

    Hence, PI or PID controller, which can increase the type of the system to eliminate the steady-state error, is not necessary in our case. For a second order systems like , is called the damping ratio, and the maximum overshoot is .

  • Transfer Function and Feedback Control System

    28427 Transfer Function and Feedback Control System An open loop transfer function of a certain unit feedback control system is described as below, where K is an adjustable gain (Proportional Controller) and G(s) is a process transfer function. 1.

  • Control System Specifications and Response

    (Note that the dead time gives a relatively small effect in the closed loop system bandwidth so a second order model is reasonable). a. Find a second order model for Ty/di (s).C = 0.5 gives the appropriately shaped response. b.

  • The Importance of Control Systems

    Feedback is at the heart of control system design and consists of two dynamical systems connected in a closed loop which allows interaction within the system.

  • Tuning methods for PID controllers

    Will 2nd and 3rd order DC Servo Motor control systems offer enough rigour and challenge to the tuning methods or should I chose another control system to model and to compare tuning methods?

  • Feedback Control Systems: Systems Specifications

    23525 Feedback Control Systems: Systems Specifications Find a second order model to achieve the following response to a step output disturbance of height 0.5. Minimum value 0.05 after 0.1s.

  • Control Systems Comparison

    Comment on the stability of the system as k varies. Figure 2 Problem 2: Consider the feedback system shown in Figure 2 above.

View More Related Solutions