Electrical and Computer Engineering Homework Solutions
Problem
#11990

Determine the average output voltage of the rectifier if the source inductance is negligible.

A six phase star rectifier has a purely resistive load of R=10 ohms, the peak supply Determine the average output voltage of the rectifier if the source inductance is negligible.voltage Vm=170V, and the supply frequency 60 Hz.

See Attached File.

Attached file(s):
Attachments
Question6.doc  View File

Attachment Content Summary (Note: view attachment at the above link before purchasing. Actual attachment content may vary slightly from that shown below.)

Question6.doc
A six phase star rectifier has a purely resistive load of R=10 ohms, the
peak supply voltage Vm=170V, and the supply frequency 60 Hz. Determine
the average output voltage of the rectifier if the source inductance is
negligible.

Answers

1) 120V

2) 162.34V

3) 169.3V
Solution
What is this?
By OTA - Overall OTA Rating
Purchase Cost Now
$2.19 CAD (was ~$11.97)
Included in Download
  • Plain text response
  • Attached file(s):
    • Solution for Posting 11990.doc
Why you can trust BrainMass.com
  • Your Information is Secure
  • Best Online Academic Help Service
  • Students find real academic Success
Related Solutions
  • [11.13] Power Electronics - A single-phase bridge rectifier - [11.13] A single-phase bridge rectifier has a purely resistive load R=10 Ohms, the peak supply voltage Vm=170 V, and the supply frequency f=60 Hz. Determine the average output voltage of the rectifier ...
  • [9.11] Power electronics - [Power electronics] A six-phrase star rectifier has a purely resistive load of R=10 Ohms. The peak supply voltage Vm=170 V, and the supply frequency f=60 Hz. Determine the average output voltage of th ...
  • Determine the RMS Output Voltage - The single-phase full-wave AC voltage control in figure below has a resistive load of R=5 ohms and the input voltage is Vs=120V RMS, 60 Hz. The delay angles of the thyristors T1 and T2 are equal: Alph ...
  • Magnitude of ac input - Magnitude of ac input. See attached file for full problem description.
  • ripple voltage in diode circuit - Determine the capacitance required in a half wave rectifier to produce a ripple voltage less than 0.2V. Assume that the input is a 60Hz signal with maximum voltage VM=100V and the load resistance R= 1 ...
Browse